Notifications
Clear all
Henryhbk
Henryhbk
Group: Registered
Joined: 2017/09/24
Trusted Member
3
Oh sorry if I gave the impression that I had just done a FW ...

In forum Hardware, firmware and software help

3 months ago
No. It never spins. Support had me swap the 2 fans and the p...

In forum Hardware, firmware and software help

3 months ago
Sorry it has been frustrating (been there done that), one th...

In forum Assembly and first prints troubleshooting

3 months ago
That’s a good point, but feedback to the company for UX is a...

In forum General discussion, announcements and releases

3 months ago
Although they did note the spool holder posts on the XL were...

In forum General discussion, announcements and releases

3 months ago
Hot End Fan not spinning

In forum Hardware, firmware and software help

3 months ago
So in bonkers print job land, it seems (if a slicer could su...

In forum General discussion, announcements and releases

4 months ago
Hotend fan (not part cooling fan) running at full for no rea...

In forum Hardware, firmware and software help

4 months ago
So Update to the project. Got the slab (24"x24" (61x61cm) it...

In forum General discussion, announcements and releases

5 months ago
You can get paid quite well if you 3D print as part of anoth...

In forum General discussion, announcements and releases

5 months ago
That’s the correct answer. If you need 3 colors and that’s y...

In forum General discussion, announcements and releases

5 months ago
DeskTop metal printing is already possible and “easy” given ...

In forum General discussion, announcements and releases

5 months ago
Yes, when I was getting mulch over at Home Depot I did find ...

In forum General discussion, announcements and releases

5 months ago
OK so my current build is going to be a cast high-pressure c...

In forum General discussion, announcements and releases

6 months ago
Best vibration absorption for table?

In forum General discussion, announcements and releases

6 months ago
@bob, Thanks. I do the same, but at least depending on the f...

In forum Hardware, firmware and software help

8 months ago
Filament swap question

In forum Hardware, firmware and software help

8 months ago
Multi-color switching question

In forum General discussion, announcements and releases

8 months ago
UX for the reset button

In forum General discussion, announcements and releases

9 months ago
Honestly I would prefer wired Ethernet (I have gigabit right...

In forum General discussion, announcements and releases

10 months ago
Page 1 / 3
Share: