Notifications
Clear all
joeybronzoni
joeybronzoni
Group: Registered
Joined: 2021/06/27
Eminent Member
2
What GPU setup do you have. I was having that issue running ...

In forum PrusaSlicer

6 months ago
Hey thanks for the talk. Yea you're right about isolating on...

In forum Hardware, firmware and software help

6 months ago
It can't be the settings or calibration at this point right?...

In forum Hardware, firmware and software help

6 months ago
Great post. I imagined that this would be possible but haven...

In forum General discussion, announcements and releases

6 months ago
HAHAHAHAHAHAHAH!!!! As soon as I left that post I turn aroun...

In forum Hardware, firmware and software help

6 months ago
Hey thanks. Yea you are right about the sensor calibration. ...

In forum Hardware, firmware and software help

6 months ago
This has turned into a rage venting thread for me. I do wan...

In forum Hardware, firmware and software help

6 months ago
I DO NOT UNDERSTAND IT!!!! I haven't changes ANYTHING and al...

In forum Hardware, firmware and software help

6 months ago
Yup, it is with a big order so it hasn't shipped yet. I'll r...

In forum Hardware, firmware and software help

7 months ago
Yea at this point I have no idea. Ever since the latest fir...

In forum Hardware, firmware and software help

7 months ago
Hey do you remember or know if your S.P.I.N.D.A. was reading...

In forum Hardware, firmware and software help

7 months ago
Here are some links that I think are helpful. The MMU2S is "...

In forum Hardware, firmware and software help

7 months ago
Yea much of the same here. Lucky if I had a dozen prints thr...

In forum Hardware, firmware and software help

7 months ago
Ok I'm back. I've cooled off a bit. I can't believe how fini...

In forum Hardware, firmware and software help

7 months ago
I'm almost there.... almost to where I'm going to through th...

In forum Hardware, firmware and software help

7 months ago
I LIED... I cannot figure this out. The MMU2S is toast. I'm ...

In forum Hardware, firmware and software help

7 months ago
I've had the same issues I've calibrated, adjusted, replaced...

In forum Hardware, firmware and software help

7 months ago
I've been getting an insane amount of issues with my MMU2S l...

In forum Hardware, firmware and software help

7 months ago
Yep I am running vanilla Arch and have the same issue. I'm l...

In forum PrusaSlicer

8 months ago
Son of a gun.... New Prusa XL model coming out. You are kill...

In forum General discussion, announcements and releases

10 months ago
Page 1 / 2
Share: