Activity
 
Notifications
Clear all
Brad
Brad
Group: Registered
Joined: 2021/05/15
Trusted Member
3
Handy tip for the next time I have to do this. Thanks.

In forum Hardware, firmware and software help

4 weeks ago
I suspect that "Galaxy" can not be protected. There are quit...

In forum General discussion, announcements and releases

2 months ago
On the Mk3S+ the issue of the button press not being registe...

In forum Hardware, firmware and software help

2 months ago
I was thinking about that but my text is on the same layers ...

In forum PrusaSlicer

3 months ago
Arachne does seem to help a lot with bulge but it is causing...

In forum PrusaSlicer

3 months ago
Sorry @rinkel, I seem to have got a bit confused now... Are ...

In forum PrusaSlicer

3 months ago
Yes my model was bulge-free when I tried it in Cura. It othe...

In forum PrusaSlicer

3 months ago
"Detect thin walls" slightly improved the bulge but broke th...

In forum PrusaSlicer

3 months ago
I tried copying some of the other default Cura settings to P...

In forum PrusaSlicer

3 months ago
The bulge has been a non-stop problem for me for most of my ...

In forum PrusaSlicer

3 months ago
I had an Ender 3 for some time and eventually purchased a MK...

In forum General discussion, announcements and releases

3 months ago
I think that this is normal with the smooth sheet (including...

In forum Hardware, firmware and software help

4 months ago
I doubt that a third party (the Etsy seller) would have been...

In forum General discussion, announcements and releases

4 months ago
I second what @Diem says. Also, sometimes you get marks on t...

In forum Hardware, firmware and software help

4 months ago
Yes there is a lot of stolen stuff on the Internet being sol...

In forum General discussion, announcements and releases

4 months ago
It could be poor internal lubrication of the bearings, possi...

In forum Assembly and first prints troubleshooting

4 months ago
Patent laws are not really fit for purpose these days as it ...

In forum General discussion, announcements and releases

4 months ago
Prusa's own support documentation states that you are likely...

In forum General discussion, announcements and releases

5 months ago
RE: Extruder still constantly plugging/clicking - what else ...

In forum General discussion, announcements and releases

5 months ago
True

In forum General discussion, announcements and releases

5 months ago
Page 1 / 5
Share: