Activity
 
Notifications
Clear all
Stefan
Stefan
Group: Registered
Joined: 2021/05/14
Trusted Member
3
I think having a hint like "Current settings for "slow down ...

In forum PrusaSlicer

3 weeks ago
i voted for one XL. Reasons: Much more versatile machine wi...

In forum General discussion, announcements and releases

2 months ago
Ich habe dort mal gestöbert und laut den AGB sind Privatpers...

In forum Allgemeine Diskussion, Ankündigungen und Veröffentlichungen

2 months ago
The horse in this case is NOT Prusa, for sure... I am worrie...

In forum Assembly and first prints troubleshooting

3 months ago
So, then this is your justification for ordering it 😀 Prusa...

In forum General discussion, announcements and releases

3 months ago
You should contact Prusa support and tell them this. Maybe a...

In forum General discussion, announcements and releases

3 months ago
clicking on your picture and seeing it entirely , it looks l...

In forum General discussion, announcements and releases

3 months ago
read the data sheet for this material. They say the material...

In forum General discussion, announcements and releases

4 months ago
i repeat my warning about hail 😀 i would use only Polyamide...

In forum How do I print this? (Printing help)

4 months ago
Use the "Cut" tool instead, to cut away a piece of the model...

In forum PrusaSlicer

4 months ago
I cannot resist... 😀 : What a stupid response to a 2 years...

In forum Hardware, firmware and software help

4 months ago
if i would do this in 3D-Printing at all, i think the only s...

In forum How do I print this? (Printing help)

4 months ago
very good information provided by a filament manufacturer:

In forum General discussion, announcements and releases

4 months ago
Do you expect the filament to stay dry forever in its packag...

In forum General discussion, announcements and releases

4 months ago
This sounds familiar to me 😀 One source of really bad noises...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Durch herumgooglen 😀 bin ich auf folgende Seite gekommen, w...

In forum Zusammenbau und Fehlersuche bei den ersten Druckversuchen

5 months ago
Hello, i do not own the Revo yet but will buy one as soon as...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Thank you! On your graph one can hardly differentiate betwee...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Yes, of course. Here is a graph of printing at 273°C with th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
i would like to see how stable the print temperature control...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Page 1 / 4
Share: