Notifications
Clear all
vanayad
vanayad
Group: Registered
Joined: 2021/05/12
Eminent Member
2
For that volume, I'd need a 0.6 nozzle and a 370mm infill sp...

In forum Hardware, firmware and software help

12 months ago
It was a reduction of about 40h in time overall (from 100 ho...

In forum Hardware, firmware and software help

12 months ago
I think it can do more than 45mm3/s, I've been told to simpl...

In forum Hardware, firmware and software help

12 months ago
Indeed, the slow down if layer print time is below X was the...

In forum Hardware, firmware and software help

12 months ago
Increasing printing speeds doesn't lower printing time

In forum Hardware, firmware and software help

12 months ago
Hi, even after unclogging the dragon (coldpulls + material e...

In forum Hardware, firmware and software help

1 year ago
I remove the clog, extrude some material to make sure it is ...

In forum Hardware, firmware and software help

1 year ago
Anyone got any ideas on how to fix the clogging? 🙁 I've tri...

In forum Hardware, firmware and software help

1 year ago
so you're printing with a dragon high flow with a 0.4 nozzle...

In forum Hardware, firmware and software help

1 year ago
Nope, it is open... 🙁

In forum Hardware, firmware and software help

1 year ago
I'm printing this:/p>

In forum Hardware, firmware and software help

1 year ago
I cannot print it, the 0.4 nozzle gets clogged before finish...

In forum Hardware, firmware and software help

1 year ago
Could it be that it is a high flow hot end and I'm using a 0...

In forum Hardware, firmware and software help

1 year ago
I have not, but I will. I doubt it is a filament issue, I'm ...

In forum Hardware, firmware and software help

1 year ago
I changed the nozzle and printed another benchy. Same result...

In forum Hardware, firmware and software help

1 year ago
I was wondering if the issue could be the nozzle? I'm using ...

In forum Hardware, firmware and software help

1 year ago
Do note that it was really hard to get the filament flowing....

In forum Hardware, firmware and software help

1 year ago
Several. It comes out clean.

In forum Hardware, firmware and software help

1 year ago
Dragon Hotend Mod keeps...clogging? I don't know exactly. St...

In forum Hardware, firmware and software help

1 year ago
Extruder prints for a few minutes then grinds some filament....

In forum Assembly and first prints troubleshooting

1 year ago
Page 1 / 2
Share: