Notifications
Clear all
John Doe
John Doe
Group: Registered
Joined: 2021/05/04
Active Member
1
Dan Rogers, you were right again. Even though I repositione...

In forum Assembly and first prints troubleshooting

11 months ago
Z Axis crash

In forum Assembly and first prints troubleshooting

11 months ago
Thank you, this did seem to solve the problem... for the X a...

In forum Assembly and first prints troubleshooting

11 months ago
X Axis failure

In forum Assembly and first prints troubleshooting

11 months ago
Ah! We already suspected that but it's nice to know the mach...

In forum Hardware, firmware and software help

12 months ago
Still trying to figure out this multimeter I bought. There ...

In forum Hardware, firmware and software help

12 months ago
Thank you for this response. I haven't done any of this yet...

In forum Hardware, firmware and software help

12 months ago
I'm not sure how to answer that, it used to heat up to 210 o...

In forum Hardware, firmware and software help

12 months ago
Nozzle won't heat up past 25 Celsius

In forum Hardware, firmware and software help

12 months ago
I'm fairly new with all this but I had a similar problem abo...

In forum Hardware, firmware and software help

1 year ago
@dan-rogers Yeah, the control panel has nothing going to it....

In forum Hardware, firmware and software help

1 year ago
I've rechecked the cords a third time. It would seem despit...

In forum Hardware, firmware and software help

1 year ago
So red is the color of a working board? I just built my Pru...

In forum Assembly and first prints troubleshooting

1 year ago
RE: Partial Power after assembled

In forum Hardware, firmware and software help

1 year ago
Partial Power after assembled

In forum Hardware, firmware and software help

1 year ago
Share: