Notifications
Clear all
Carl A
Carl A
Skupina: Registrovaný
Přidal se: 2017/06/12
Estimable Member
4
Interesting...let it set overnight and wala, it started up O...

In forum Hardware, firmware and software help

před 12 months
I keep an XP laptop because later windows do not support my ...

In forum PrusaSlicer

před 1 year
The new OS is always a pain as a new computer means you have...

In forum PrusaSlicer

před 1 year
Forgot to mention that both fans are running and that I cann...

In forum Hardware, firmware and software help

před 1 year
Printer does not boot up

In forum Hardware, firmware and software help

před 1 year
Finally found the problem. Both of my MOLEX fittings that co...

In forum Hardware, firmware and software help

před 2 years
Well, I just could not accept that the PSU went bad so I wen...

In forum Hardware, firmware and software help

před 2 years
Yep, spoke too soon. The initial tests went ok. Started a pr...

In forum Hardware, firmware and software help

před 2 years
Well all but for the loss of a horseshoe nail..... Ordered a...

In forum Hardware, firmware and software help

před 2 years
Can I assume that no ferther options are being offered that ...

In forum Hardware, firmware and software help

před 2 years
Now not sure about the ticket number but this Forum chain ha...

In forum Hardware, firmware and software help

před 2 years
Karl, the ticker # is for Ultimchine I believe but will chec...

In forum Hardware, firmware and software help

před 2 years
Room temperature kept at about 25 to 27 C. No fans blowing o...

In forum Hardware, firmware and software help

před 2 years
Well it is back again. Same problem. I did a reflash and it ...

In forum Hardware, firmware and software help

před 2 years
Prusa Mk 3S+

In forum PrusaSlicer

před 2 years
RE: Bed fan speed when printing ABS

In forum General software discussion

před 2 years
Seems that the site will not post the pics or at least I can...

In forum General software discussion

před 2 years
The plexiglass allows me to see from all angles. The mirror ...

In forum General software discussion

před 2 years
I failed to mention that my variable speed exhaust fan has c...

In forum General software discussion

před 2 years
I have sent the problem to GITHUB under ticket #2898. Referr...

In forum Hardware, firmware and software help

před 2 years
Stránka 1 / 6
Share: