Notifications
Clear all
TwoBallScrewBall
TwoBallScrewBall
Grupa: Zarejestrowany
Dołączył: 2021/01/24
Trusted Member
3
Bed Thermal Sensor Wire Breaking

In forum Hardware, firmware and software help

2 weeks temu
I do have old G-codes. How do I pull settings out of those?

In forum How do I print this? (Printing help)

1 year temu
Right now, this is basically the stock Prusament PETG profil...

In forum How do I print this? (Printing help)

1 year temu
Slowing down does help. All 4 boxes were oriented on the p...

In forum How do I print this? (Printing help)

1 year temu
One last thing lol, I have two printers, I attempted the pri...

In forum How do I print this? (Printing help)

1 year temu
This is a MK3S+ printer, overture PETG, my temp settings are...

In forum How do I print this? (Printing help)

1 year temu
Thoughts on these defects please?

In forum How do I print this? (Printing help)

1 year temu
Being the one that started this thread, I had no idea it wou...

In forum Hardware, firmware and software help

1 year temu
Thanks to all that replied. The new SuperPINDA arrived yes...

In forum Hardware, firmware and software help

1 year temu
Thanks! I'll have to check out that M3-18 screw mod. Than...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year temu
I should have the new SPinda by the end of the week so I wil...

In forum Hardware, firmware and software help

1 year temu
I did 🙂 Both are 3-pin plugs. Both have a "Superpinda" la...

In forum Hardware, firmware and software help

1 year temu
They are both MK3s+ models for sure. Slow printer was shi...

In forum Hardware, firmware and software help

1 year temu
Who said I'm not prepared to check electronics? All I said...

In forum Hardware, firmware and software help

1 year temu
This was a great catch!!! I had not noticed that, but you ar...

In forum Hardware, firmware and software help

1 year temu
I have not swapped pindas, as I do not want to unnecessarily...

In forum Hardware, firmware and software help

1 year temu
This printer has been this way since it was new. I've also ...

In forum Hardware, firmware and software help

1 year temu
Thanks Robin. Keep in mind, I am now using a nut driver (s...

In forum Hardware, firmware and software help

1 year temu
So update, I worked with Prusa support on this for a couple ...

In forum Hardware, firmware and software help

1 year temu
Yup, got that 🙂 In the photo above of the cleaned up hot e...

In forum Hardware, firmware and software help

1 year temu
Strona 1 / 4
Share: