Notifications
Clear all
TwoBallScrewBall
TwoBallScrewBall
Groupe: Enregistré
A(ont) rejoint: 2021/01/24
Trusted Member
3
MK3S+ Total Cost Shipped to US now?

Dans le forum General discussion, announcements and releases

il y a 1 week
Bed Thermal Sensor Wire Breaking

Dans le forum Hardware, firmware and software help

il y a 4 weeks
I do have old G-codes. How do I pull settings out of those?

Dans le forum How do I print this? (Printing help)

il y a 1 year
Right now, this is basically the stock Prusament PETG profil...

Dans le forum How do I print this? (Printing help)

il y a 1 year
Slowing down does help. All 4 boxes were oriented on the p...

Dans le forum How do I print this? (Printing help)

il y a 1 year
One last thing lol, I have two printers, I attempted the pri...

Dans le forum How do I print this? (Printing help)

il y a 1 year
This is a MK3S+ printer, overture PETG, my temp settings are...

Dans le forum How do I print this? (Printing help)

il y a 1 year
Thoughts on these defects please?

Dans le forum How do I print this? (Printing help)

il y a 1 year
Being the one that started this thread, I had no idea it wou...

Dans le forum Hardware, firmware and software help

il y a 1 year
Thanks to all that replied. The new SuperPINDA arrived yes...

Dans le forum Hardware, firmware and software help

il y a 1 year
Thanks! I'll have to check out that M3-18 screw mod. Than...

Dans le forum User mods - OctoPrint, enclosures, nozzles, ...

il y a 1 year
I should have the new SPinda by the end of the week so I wil...

Dans le forum Hardware, firmware and software help

il y a 1 year
I did 🙂 Both are 3-pin plugs. Both have a "Superpinda" la...

Dans le forum Hardware, firmware and software help

il y a 1 year
They are both MK3s+ models for sure. Slow printer was shi...

Dans le forum Hardware, firmware and software help

il y a 1 year
Who said I'm not prepared to check electronics? All I said...

Dans le forum Hardware, firmware and software help

il y a 1 year
This was a great catch!!! I had not noticed that, but you ar...

Dans le forum Hardware, firmware and software help

il y a 1 year
I have not swapped pindas, as I do not want to unnecessarily...

Dans le forum Hardware, firmware and software help

il y a 1 year
This printer has been this way since it was new. I've also ...

Dans le forum Hardware, firmware and software help

il y a 1 year
Thanks Robin. Keep in mind, I am now using a nut driver (s...

Dans le forum Hardware, firmware and software help

il y a 1 year
So update, I worked with Prusa support on this for a couple ...

Dans le forum Hardware, firmware and software help

il y a 1 year
Page 1 / 4
Partager :