Activity
 
Notifications
Clear all
PaulB
PaulB
Group: Registered
Joined: 2021/01/18
Trusted Member
3
That benchy was with Overture PLA, I have had equally good ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Is everyone having issues with their Revo Micro? For me it's...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Unless i'm mistaken, I think the fan speed is fixed. Apparen...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
It doesn't recommend PID tuning, just says 'If you feel the ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
I think it might be these, but more reasonable with £4.95 de...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Yeah, 20€ for delivery, no thanks!

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Would be happy to do this by a bit of trial and error, but t...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
I cant see why this is simpler than just calculating the len...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Hi, I installed a Revo Micro on my Mini+ over the weekend, I...

In forum User mods - OctoPrint, enclosures, nozzles, ...

5 months ago
Randomise position of print to extend print surface?

In forum PrusaSlicer

7 months ago
I changed for a number of reasons. I had had a few cases of ...

In forum How do I print this? (Printing help)

9 months ago
It’s working a treat now.  86F332B9-3311-421B-A716-6...

In forum How do I print this? (Printing help)

9 months ago
OK, thank you, I am now getting decent prints. I'm always co...

In forum How do I print this? (Printing help)

9 months ago
So I have done, a few days back, I'll definitely try again.

In forum How do I print this? (Printing help)

9 months ago
So I checked and there's nothing under the sheet. The SuperP...

In forum How do I print this? (Printing help)

9 months ago
So its securely screwed in, probably not as high as that, bu...

In forum How do I print this? (Printing help)

9 months ago
That test was me doing the Live Z bed levelling as suggested...

In forum How do I print this? (Printing help)

9 months ago
Now i'm really confused. The right-hand side is almost touch...

In forum How do I print this? (Printing help)

9 months ago
Ok so I think my issus is that my bed is seriously not level...

In forum How do I print this? (Printing help)

9 months ago
I did change the steps. I'll read the post, thanks

In forum How do I print this? (Printing help)

9 months ago
Page 1 / 5
Share: