Notifications
Clear all
Cashew92ftw
Cashew92ftw
Group: Registered
Joined: 2021/01/13
Trusted Member
3
Wouldnt that mean i would have heat creep when i switch back...

In forum Hardware, firmware and software help

6 months ago
I did double check for the 0.4 nozzle, both on the slicer an...

In forum Hardware, firmware and software help

6 months ago
Nozzle X Underextruding

In forum Hardware, firmware and software help

6 months ago
Thanks for the heads up.

In forum General discussion, announcements and releases

7 months ago
Im going to guess july.

In forum General discussion, announcements and releases

7 months ago
Looking forward to see what other addons will be available ...

In forum General discussion, announcements and releases

8 months ago
I was looking forward to the idea of a mk4. Prettymuch a mk3...

In forum General discussion, announcements and releases

10 months ago
@averageprintingjoe I see you may not be expiereced with the...

In forum General discussion, announcements and releases

1 year ago
@averageprintingjoe What are your thoughts on remote drive s...

In forum General discussion, announcements and releases

1 year ago
@neolker Did you ever do any rfid testing on the buddy board...

In forum Hardware, firmware and software help

1 year ago
@szkifi I measured about 175 cm for the printer to powerbric...

In forum General discussion, announcements and releases

1 year ago
@altarus I think its the bolt and nut, though tbh i think my...

In forum General discussion, announcements and releases

1 year ago
@oxygen I honstly havent bothered going back to the other 2 ...

In forum General discussion, announcements and releases

1 year ago
@oxygen Its got a nice feel on the first layer imo  1...

In forum General discussion, announcements and releases

1 year ago
Dont forget you can set it up as a custom sheet under HW 🙂 ...

In forum General discussion, announcements and releases

1 year ago
They print amasingly IMO. I snagged one with my kit while i ...

In forum General discussion, announcements and releases

1 year ago
@cwbullet have you reviewed the satin sheet yet? Defidently ...

In forum General discussion, announcements and releases

1 year ago
@schnoidz right on, and id cover your order number there, do...

In forum General discussion, announcements and releases

1 year ago
@schnoidz i would just talk to their customer service throug...

In forum General discussion, announcements and releases

1 year ago
@raymate right on man. Like i said i got it on a whim, and 0...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 3
Share: