Activity
 
Notifications
Clear all
carl.g
carl.g
Group: Registered
Joined: 2017/04/09
Trusted Member
3
@carl-g, could you please expand on the issue with the silve...

In forum General discussion, announcements and releases

2 months ago
I wish I'd seen that earlier. I certainly didn't read that ...

In forum General discussion, announcements and releases

2 months ago
Having a little sit down and some tucker before adding the d...

In forum General discussion, announcements and releases

2 months ago
I ordered 05/May/2022 arrived today 10/Aug/2022

In forum General discussion, announcements and releases

2 months ago
Silver Power Supplies

In forum Assembly and troubleshooting

2 months ago
I ordered 05/05/2022

In forum General discussion, announcements and releases

2 months ago
Thanks is for the update. I should get mine on Wednesday ap...

In forum General discussion, announcements and releases

2 months ago
Mine will be with me on Wednesday apparently 😀

In forum General discussion, announcements and releases

2 months ago
Thanks for the updates 🙂

In forum General discussion, announcements and releases

2 months ago
Thanks Mclarion, some actual info. 🙂

In forum General discussion, announcements and releases

2 months ago
Enclosure Shipping Date

In forum General discussion, announcements and releases

2 months ago
Mine did look like that for the last couple of weeks as I br...

In forum General discussion, announcements and releases

3 years ago
Great news there Brad. 😀 I've just printed the idler doo...

In forum Assembly and first prints troubleshooting

3 years ago
My sensor arm is mid-green PLA; working just fine. Peter ...

In forum Assembly and first prints troubleshooting

3 years ago
I've just had this problem too. Thanks for the advice above...

In forum Assembly and first prints troubleshooting

3 years ago
The standard Prusa spool holder Duplicate, mirror and ali...

In forum Hardware, firmware and software help

4 years ago
May I suggest you simply print the standard Prusa spool hold...

In forum Hardware, firmware and software help

4 years ago
I use Elmer's School Glue Stick. The purple stuff. It's no...

In forum How do I print this? (Printing help)

4 years ago
Are those rough surfaces on the back of the print? That is,...

In forum Assembly and first prints troubleshooting

4 years ago
Try increasing the filament temperature about 10°C. It look...

In forum Assembly and first prints troubleshooting

4 years ago
Page 1 / 4
Share: