Notifications
Clear all
DarkKnight
DarkKnight
Group: Registered
Joined: 2020/12/13
Eminent Member
2
Paint the color/material of non-visible interior area

In forum PrusaSlicer

4 months ago
MK3S+ Temperature calibration is way off.

In forum Hardware, firmware and software help

12 months ago
The mmu is cool, but it's a lot of trouble. Printing new ext...

In forum General discussion, announcements and releases

1 year ago
I use a set similar to this:but it's an old Craftsman Profes...

In forum General discussion, announcements and releases

1 year ago
I mean the setting in the printer interface, not the slicer....

In forum General discussion, announcements and releases

1 year ago
Presets vs Filament recommendations

In forum General discussion, announcements and releases

1 year ago
Presets vs Filament recommendations

In forum General discussion, announcements and releases

1 year ago
FINDA probe behaving erratically

In forum Hardware, firmware and software help

2 years ago
For the life of me I could not get the factory supplied PETG...

In forum Hardware, firmware and software help

2 years ago
@paulhostettler 3D printing, IMHO, is not exactly a casual h...

In forum Hardware, firmware and software help

2 years ago
@towlerg I do use octoprint, but even bypassing this process...

In forum Hardware, firmware and software help

2 years ago
I would start by examining the voltages on your PSU while th...

In forum Hardware, firmware and software help

2 years ago
A few things that come to mind are (in approximate order of ...

In forum Hardware, firmware and software help

2 years ago
It looks like you are using non-standard equipment, so it's ...

In forum Hardware, firmware and software help

2 years ago
So I literally cannot get the slicer to output code that the...

In forum Hardware, firmware and software help

2 years ago
I should add to this that on top of everything else, there i...

In forum Hardware, firmware and software help

2 years ago
Problems with Prusa Slicer usability

In forum Hardware, firmware and software help

2 years ago
Thank you everyone, particularly @joantabb, for the informed...

In forum General discussion, announcements and releases

2 years ago
@karl-herbert What holding current is necessary for motors t...

In forum General discussion, announcements and releases

2 years ago
Z axis motors warm when idle

In forum General discussion, announcements and releases

2 years ago
Share: