Notifications
Clear all
TeachingTheDetails
TeachingTheDetails
Group: Registered
Joined: 2020/11/17
Eminent Member
2
Thank you everyone. This really healps to understand support...

In forum PrusaSlicer

6 months ago
Attached is the .3mf file with the settings how I printed it...

In forum PrusaSlicer

6 months ago
Edit-timer ran out. When using Paint-on Support, it also ...

In forum PrusaSlicer

6 months ago
My apologies, really should have included the image in the f...

In forum PrusaSlicer

6 months ago
"Support blocker" doesn't affect supports from "Support enfo...

In forum PrusaSlicer

6 months ago
Never figured out, what the issue was, but it's working fine...

In forum General software discussion

7 months ago
Yes, I didn't realize, that option also had to be enabled in...

In forum PrusaSlicer

7 months ago
@Neophyl Without "use volumetric E", it prints fine with an ...

In forum PrusaSlicer

8 months ago
Not sure, if you've the exact same problem, but my Mini used...

In forum Hardware, firmware and software help

8 months ago
Sorry, meant extrusion multiplier, not flowrate. On the Cr-1...

In forum PrusaSlicer

8 months ago
PrusaSlicer requires really low Flowrate to not overextrude?

In forum PrusaSlicer

8 months ago
Bondtech CHT profile?

In forum Hardware, firmware and software help

8 months ago
Printing TPU on a stock mini, the extruder has zero problems...

In forum How do I print this? (Printing help)

8 months ago
Looks great 😀

In forum PrusaSlicer

8 months ago
Perfect, those placeholder changes worked. Now it's slicing ...

In forum PrusaSlicer

8 months ago
"Invalid data" when slicing? G-code is messed up...

In forum PrusaSlicer

8 months ago
Found a workable solution: There's an "outer brim only" opti...

In forum PrusaSlicer

8 months ago
Build improvement idea for the Mini

In forum Hardware, firmware and software help

8 months ago
When trying the method with 0 perimeters or infill, the Slic...

In forum PrusaSlicer

8 months ago
Add Brim to specific sections only?

In forum PrusaSlicer

8 months ago
Page 1 / 3
Share: