Attività
 
Notifiche
Cancella tutti
Zorro_X
Zorro_X
Gruppo: Registrato
Registrato: 2020/11/08
Eminent Member
2
Any other suggestion about what can be the cause of my probl...

Nel forum Hardware, firmware and software help

1 year fa
I'm also having similar troubles since update from MK3S to M...

Nel forum Hardware, firmware and software help

1 year fa
I've tried previous gcode files and they works much better t...

Nel forum Hardware, firmware and software help

1 year fa
OK, but I've not flashed it since before the MK3S+ update : ...

Nel forum Hardware, firmware and software help

1 year fa
Hi, it is interesting, I have a similar problem here () but ...

Nel forum Hardware, firmware and software help

1 year fa
Thankyou, but I already do that : I've two sheets and each o...

Nel forum Hardware, firmware and software help

1 year fa
I've also tried to "cheat" by calibrating the Z height "on f...

Nel forum Hardware, firmware and software help

1 year fa
First layer flow problem

Nel forum Hardware, firmware and software help

1 year fa
ok, thankyou for the advices.I don't understand why this hap...

Nel forum Hardware, firmware and software help

2 years fa
@cwbullet I've tried octofiber and it was unable to stick to...

Nel forum Hardware, firmware and software help

2 years fa
@cwbullet nope, it seems to happen only with PET-G prints, b...

Nel forum Hardware, firmware and software help

2 years fa
@cwbullet ok, so when it is cold (so I can touch it) I don't...

Nel forum Hardware, firmware and software help

2 years fa
@cwbullet nope, and the belts are tight...

Nel forum Hardware, firmware and software help

2 years fa
X shift, Z not constant and play noise

Nel forum Hardware, firmware and software help

2 years fa
@tim-m30 hi, thankyou, I've got near the same tip from anoth...

Nel forum Hardware, firmware and software help

2 years fa
Filament stuck on top of PTFE

Nel forum Hardware, firmware and software help

2 years fa
@tim-m30 thankyou, I'm just finishing my octofiber filament ...

Nel forum How do I print this? (Printing help)

2 years fa
Hi, thankyou, i'll try 80°, but 90° clearly seems too hot fo...

Nel forum How do I print this? (Printing help)

2 years fa
Printing PET-G octofiber with i3 MK3S

Nel forum How do I print this? (Printing help)

2 years fa
Sorry, the problem was me. In my case everything is OK now.

Nel forum Assembly and first prints troubleshooting

2 years fa
Pagina 1 / 2
Condividi: