Activité
 
Notifications
Clear all
Zorro_X
Zorro_X
Groupe: Enregistré
A(ont) rejoint: 2020/11/08
Eminent Member
2
Any other suggestion about what can be the cause of my probl...

Dans le forum Hardware, firmware and software help

il y a 12 months
I'm also having similar troubles since update from MK3S to M...

Dans le forum Hardware, firmware and software help

il y a 1 year
I've tried previous gcode files and they works much better t...

Dans le forum Hardware, firmware and software help

il y a 1 year
OK, but I've not flashed it since before the MK3S+ update : ...

Dans le forum Hardware, firmware and software help

il y a 1 year
Hi, it is interesting, I have a similar problem here () but ...

Dans le forum Hardware, firmware and software help

il y a 1 year
Thankyou, but I already do that : I've two sheets and each o...

Dans le forum Hardware, firmware and software help

il y a 1 year
I've also tried to "cheat" by calibrating the Z height "on f...

Dans le forum Hardware, firmware and software help

il y a 1 year
First layer flow problem

Dans le forum Hardware, firmware and software help

il y a 1 year
ok, thankyou for the advices.I don't understand why this hap...

Dans le forum Hardware, firmware and software help

il y a 2 years
@cwbullet I've tried octofiber and it was unable to stick to...

Dans le forum Hardware, firmware and software help

il y a 2 years
@cwbullet nope, it seems to happen only with PET-G prints, b...

Dans le forum Hardware, firmware and software help

il y a 2 years
@cwbullet ok, so when it is cold (so I can touch it) I don't...

Dans le forum Hardware, firmware and software help

il y a 2 years
@cwbullet nope, and the belts are tight...

Dans le forum Hardware, firmware and software help

il y a 2 years
X shift, Z not constant and play noise

Dans le forum Hardware, firmware and software help

il y a 2 years
@tim-m30 hi, thankyou, I've got near the same tip from anoth...

Dans le forum Hardware, firmware and software help

il y a 2 years
Filament stuck on top of PTFE

Dans le forum Hardware, firmware and software help

il y a 2 years
@tim-m30 thankyou, I'm just finishing my octofiber filament ...

Dans le forum How do I print this? (Printing help)

il y a 2 years
Hi, thankyou, i'll try 80°, but 90° clearly seems too hot fo...

Dans le forum How do I print this? (Printing help)

il y a 2 years
Printing PET-G octofiber with i3 MK3S

Dans le forum How do I print this? (Printing help)

il y a 2 years
Sorry, the problem was me. In my case everything is OK now.

Dans le forum Assembly and first prints troubleshooting

il y a 2 years
Page 1 / 2
Partager :