Notifications
Clear all
Zorro_X
Zorro_X
Skupina: Registrovaný
Přidal se: 2020/11/08
Eminent Member
2
Any other suggestion about what can be the cause of my probl...

In forum Hardware, firmware and software help

před 1 year
I'm also having similar troubles since update from MK3S to M...

In forum Hardware, firmware and software help

před 1 year
I've tried previous gcode files and they works much better t...

In forum Hardware, firmware and software help

před 1 year
OK, but I've not flashed it since before the MK3S+ update : ...

In forum Hardware, firmware and software help

před 1 year
Hi, it is interesting, I have a similar problem here () but ...

In forum Hardware, firmware and software help

před 1 year
Thankyou, but I already do that : I've two sheets and each o...

In forum Hardware, firmware and software help

před 1 year
I've also tried to "cheat" by calibrating the Z height "on f...

In forum Hardware, firmware and software help

před 1 year
First layer flow problem

In forum Hardware, firmware and software help

před 1 year
ok, thankyou for the advices.I don't understand why this hap...

In forum Hardware, firmware and software help

před 2 years
@cwbullet I've tried octofiber and it was unable to stick to...

In forum Hardware, firmware and software help

před 2 years
@cwbullet nope, it seems to happen only with PET-G prints, b...

In forum Hardware, firmware and software help

před 2 years
@cwbullet ok, so when it is cold (so I can touch it) I don't...

In forum Hardware, firmware and software help

před 2 years
@cwbullet nope, and the belts are tight...

In forum Hardware, firmware and software help

před 2 years
X shift, Z not constant and play noise

In forum Hardware, firmware and software help

před 2 years
@tim-m30 hi, thankyou, I've got near the same tip from anoth...

In forum Hardware, firmware and software help

před 2 years
Filament stuck on top of PTFE

In forum Hardware, firmware and software help

před 2 years
@tim-m30 thankyou, I'm just finishing my octofiber filament ...

In forum How do I print this? (Printing help)

před 2 years
Hi, thankyou, i'll try 80°, but 90° clearly seems too hot fo...

In forum How do I print this? (Printing help)

před 2 years
Printing PET-G octofiber with i3 MK3S

In forum How do I print this? (Printing help)

před 2 years
Sorry, the problem was me. In my case everything is OK now.

In forum Assembly and first prints troubleshooting

před 2 years
Stránka 1 / 2
Share: