Activité
 
Notifications
Clear all
jimD
jimD
Groupe: Enregistré
A(ont) rejoint: 2020/10/02
Eminent Member
2
I just remembered that I have to zip the project file so I c...

Dans le forum How do I print this? (Printing help)

il y a 9 months
file didn't append. trying again.

Dans le forum How do I print this? (Printing help)

il y a 9 months
Because of all of the modifiers that swiss_cheese helped me ...

Dans le forum How do I print this? (Printing help)

il y a 9 months
How do I get supports in an inside cavity at the bottom of a...

Dans le forum How do I print this? (Printing help)

il y a 9 months
I've used the .3mf file that you sent to successfully print ...

Dans le forum How do I print this? (Printing help)

il y a 9 months
I didn't know it existed. I'll have a look. For my applicati...

Dans le forum How do I print this? (Printing help)

il y a 12 months
Thanks for sharing the details. I think I have enough inform...

Dans le forum How do I print this? (Printing help)

il y a 12 months
I did read your reply and will go back through it now that I...

Dans le forum How do I print this? (Printing help)

il y a 12 months
I spent some time today doing side by side comparison betwee...

Dans le forum How do I print this? (Printing help)

il y a 12 months
I just replied, got an internet error and lost the 1st respo...

Dans le forum How do I print this? (Printing help)

il y a 12 months
The overhang was why I added the supports. As I said previo...

Dans le forum How do I print this? (Printing help)

il y a 12 months
Thanks for the suggestion. I removed the supports and it di...

Dans le forum How do I print this? (Printing help)

il y a 12 months
Attached is the view after it was sliced. What was showing b...

Dans le forum How do I print this? (Printing help)

il y a 12 months
I zipped the .3mf from slicer and attached it.  Sole-...

Dans le forum How do I print this? (Printing help)

il y a 12 months
I zipped the .3mf from slicer and attached it.  Sole-...

Dans le forum How do I print this? (Printing help)

il y a 12 months
Very poor print quality on underside of ABS even with suppor...

Dans le forum How do I print this? (Printing help)

il y a 12 months
Thanks, I finally heard back from the forum admin. They said...

Dans le forum Assembly and first prints troubleshooting

il y a 12 months
How do I reach a forum admin to see if my id is blocked fro...

Dans le forum Assembly and first prints troubleshooting

il y a 12 months
Not sure what I'm doing wrong. I've attached a zip of the 3m...

Dans le forum Assembly and first prints troubleshooting

il y a 1 year
last try didn't save

Dans le forum Assembly and first prints troubleshooting

il y a 1 year
Page 1 / 2
Partager :