Actividad
 
Avisos
Vaciar todo
jimD
jimD
Grupo: Registrado
Registrado: 2020/10/02
Eminent Member
2
I just remembered that I have to zip the project file so I c...

En el foro How do I print this? (Printing help)

hace 8 months
file didn't append. trying again.

En el foro How do I print this? (Printing help)

hace 9 months
Because of all of the modifiers that swiss_cheese helped me ...

En el foro How do I print this? (Printing help)

hace 9 months
How do I get supports in an inside cavity at the bottom of a...

En el foro How do I print this? (Printing help)

hace 9 months
I've used the .3mf file that you sent to successfully print ...

En el foro How do I print this? (Printing help)

hace 9 months
I didn't know it existed. I'll have a look. For my applicati...

En el foro How do I print this? (Printing help)

hace 11 months
Thanks for sharing the details. I think I have enough inform...

En el foro How do I print this? (Printing help)

hace 11 months
I did read your reply and will go back through it now that I...

En el foro How do I print this? (Printing help)

hace 11 months
I spent some time today doing side by side comparison betwee...

En el foro How do I print this? (Printing help)

hace 12 months
I just replied, got an internet error and lost the 1st respo...

En el foro How do I print this? (Printing help)

hace 12 months
The overhang was why I added the supports. As I said previo...

En el foro How do I print this? (Printing help)

hace 12 months
Thanks for the suggestion. I removed the supports and it di...

En el foro How do I print this? (Printing help)

hace 12 months
Attached is the view after it was sliced. What was showing b...

En el foro How do I print this? (Printing help)

hace 12 months
I zipped the .3mf from slicer and attached it.  Sole-...

En el foro How do I print this? (Printing help)

hace 12 months
I zipped the .3mf from slicer and attached it.  Sole-...

En el foro How do I print this? (Printing help)

hace 12 months
Very poor print quality on underside of ABS even with suppor...

En el foro How do I print this? (Printing help)

hace 12 months
Thanks, I finally heard back from the forum admin. They said...

En el foro Assembly and first prints troubleshooting

hace 12 months
How do I reach a forum admin to see if my id is blocked fro...

En el foro Assembly and first prints troubleshooting

hace 12 months
Not sure what I'm doing wrong. I've attached a zip of the 3m...

En el foro Assembly and first prints troubleshooting

hace 12 months
last try didn't save

En el foro Assembly and first prints troubleshooting

hace 12 months
Página 1 / 2
Compartir: