Activity
 
Notifications
Clear all
jimD
jimD
Group: Registered
Joined: 2020/10/02
Eminent Member
2
I just remembered that I have to zip the project file so I c...

In forum How do I print this? (Printing help)

7 months ago
file didn't append. trying again.

In forum How do I print this? (Printing help)

7 months ago
Because of all of the modifiers that swiss_cheese helped me ...

In forum How do I print this? (Printing help)

7 months ago
How do I get supports in an inside cavity at the bottom of a...

In forum How do I print this? (Printing help)

7 months ago
I've used the .3mf file that you sent to successfully print ...

In forum How do I print this? (Printing help)

7 months ago
I didn't know it existed. I'll have a look. For my applicati...

In forum How do I print this? (Printing help)

10 months ago
Thanks for sharing the details. I think I have enough inform...

In forum How do I print this? (Printing help)

10 months ago
I did read your reply and will go back through it now that I...

In forum How do I print this? (Printing help)

10 months ago
I spent some time today doing side by side comparison betwee...

In forum How do I print this? (Printing help)

10 months ago
I just replied, got an internet error and lost the 1st respo...

In forum How do I print this? (Printing help)

10 months ago
The overhang was why I added the supports. As I said previo...

In forum How do I print this? (Printing help)

10 months ago
Thanks for the suggestion. I removed the supports and it di...

In forum How do I print this? (Printing help)

10 months ago
Attached is the view after it was sliced. What was showing b...

In forum How do I print this? (Printing help)

10 months ago
I zipped the .3mf from slicer and attached it.  Sole-...

In forum How do I print this? (Printing help)

10 months ago
I zipped the .3mf from slicer and attached it.  Sole-...

In forum How do I print this? (Printing help)

10 months ago
Very poor print quality on underside of ABS even with suppor...

In forum How do I print this? (Printing help)

10 months ago
Thanks, I finally heard back from the forum admin. They said...

In forum Assembly and first prints troubleshooting

10 months ago
How do I reach a forum admin to see if my id is blocked fro...

In forum Assembly and first prints troubleshooting

10 months ago
Not sure what I'm doing wrong. I've attached a zip of the 3m...

In forum Assembly and first prints troubleshooting

11 months ago
last try didn't save

In forum Assembly and first prints troubleshooting

11 months ago
Page 1 / 2
Share: