Activity
 
Notifications
Clear all
Randy
Randy
Group: Registered
Joined: 2020/06/23
Active Member
1
Thanks @prusatv for sharing your settings. This is super he...

In forum How do I print this? (Printing help)

1 year ago
as it sounds like you may have a dodgy USB port. Agreed. It...

In forum Hardware, firmware and software help

2 years ago
Thanks for the replies everyone. I tried a couple of USB st...

In forum Hardware, firmware and software help

2 years ago
USB sticks not recognized anymore

In forum Hardware, firmware and software help

2 years ago
Thanks. I've blown the compressed air in the "access panel....

In forum How do I print this? (Printing help)

2 years ago
Good news: 3dBenchy is printed, short PTFE tube replaced, lo...

In forum How do I print this? (Printing help)

2 years ago
Thanks everyone for the replies. I finally got my replaceme...

In forum How do I print this? (Printing help)

2 years ago
Thanks for the help. I upgraded the firmware -- 4.1.0 -- bu...

In forum How do I print this? (Printing help)

2 years ago
More 💩. My filament won't load now. It just chews up in th...

In forum How do I print this? (Printing help)

2 years ago
I tried another print with the Filamentum Crystal Clear afte...

In forum How do I print this? (Printing help)

2 years ago
^^ Also, I'm still on the 4.0.5 firmware and haven't upgrade...

In forum How do I print this? (Printing help)

2 years ago
Beginner: Consistent problems with Filamentum Crystal Clear ...

In forum How do I print this? (Printing help)

2 years ago
Mini Firmware Stuck: Change filament -> Calibrate First Laye...

In forum Assembly and first prints troubleshooting

2 years ago
Share: