Prusa3D Forum

Notifications

Clear all

Muldee Things

Group: Registered

Joined: 2020/04/16

Active Member

	Thank you @fuchsr for your suggestion. Actually it was a sum... In forum How do I print this? (Printing help)	9 months ago
	Bad PETG print - Can anyone tell me what is going wrong? In forum How do I print this? (Printing help)	9 months ago
	@d0ug Watch out, I think Raspberry Pi Zero is deprecated on ... In forum Hardware, firmware and software help	2 years ago
	Well, my Prusa usb stick died pretty quickly. I'm using my o... In forum Hardware, firmware and software help	2 years ago
	@giordanososa Thank you for your reply. Yours it's a good po... In forum How do I print this? (Printing help)	2 years ago
	Problems with under extrusion (or that's what I think it is.... In forum How do I print this? (Printing help)	2 years ago
	Stringing and PrusaSlicer settings In forum How do I print this? (Printing help)	2 years ago
	@ulrike-b Thank you for your answer. Would you mind explain ... In forum General discussion, announcements and releases	2 years ago
	First layer temperatures lower than the other layers ones? In forum General discussion, announcements and releases	2 years ago
	First layer temperatures lower than the other layers ones? In forum General discussion, announcements and releases	2 years ago

Forum Statistics

422 Forums

46.7 K Topics

340.3 K Posts

2 Online

43.6 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed