Activity
 
Notifications
Clear all
jsw
jsw
Group: Registered
Joined: 2020/02/20
Famed Member
I use ABS or ASA for items that will be used outdoors or in ...

In forum General discussion, announcements and releases

3 days ago
I've found that, if anything, PETg is usually more supple an...

In forum Assembly and first prints troubleshooting

5 days ago
I run PLA, ABS, and PETg in the Prusa (and the Ultimaker) re...

In forum How do I print this? (Printing help)

6 days ago
FYI, another 'XL' ...

In forum General discussion, announcements and releases

2 weeks ago
Most of today's off-the-shelf power supplies, as in those in...

In forum General discussion, announcements and releases

2 weeks ago
I must admit that this is a novel design, since it encloses ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 weeks ago
I regularly print PLA in an enclosure with the door shut. If...

In forum Hardware, firmware and software help

3 weeks ago
There was a discussion on this on 'another network' not that...

In forum General discussion, announcements and releases

3 weeks ago
Yes, what will certainly happen one month into ownership, pa...

In forum General discussion, announcements and releases

3 weeks ago
I guess it must be another spam control thing.

In forum General discussion, announcements and releases

3 weeks ago
More often than not, I've found that the default temperature...

In forum Assembly and first prints troubleshooting

3 weeks ago
One often-overlooked item is that the textured plate needs a...

In forum Assembly and first prints troubleshooting

3 weeks ago
This may be fixed. I just successfully replied to a thread s...

In forum General discussion, announcements and releases

3 weeks ago
I've successfully pulled out the top of the stuck filament b...

In forum Assembly and first prints troubleshooting

3 weeks ago
If the Z calibration is a 'nightmare', something is definite...

In forum Assembly and first prints troubleshooting

3 weeks ago
The account looks valid, and I am able to leave him a PM. Ma...

In forum General discussion, announcements and releases

3 weeks ago
Forum issue - cannot leave response WRT user asking for help...

In forum General discussion, announcements and releases

3 weeks ago
I say that because when I started printing small gears for s...

In forum Assembly and first prints troubleshooting

4 weeks ago
I can confirm that at least some of the Prusa branded filame...

In forum Assembly and first prints troubleshooting

4 weeks ago
I always keep the door on my enclosure shut when printing, e...

In forum User mods, enclosures, nozzles, ...

4 weeks ago
Page 1 / 149
Share: