Notifications
Clear all
buckeyestargazer
buckeyestargazer
Group: Registered
Joined: 2020/02/18
Estimable Member
4
Actually I think I figured it out. The pin that holds the t...

In forum Hardware, firmware and software help

2 weeks ago
Well after several hours of print time with this noise the p...

In forum Hardware, firmware and software help

2 weeks ago
I tried two different ways to attach the video here and neit...

In forum Hardware, firmware and software help

2 weeks ago
Extruder noise, but probably not nozzle clog.

In forum Hardware, firmware and software help

2 weeks ago
Just to close out this thread, I replaced the hot end includ...

In forum General discussion, announcements and releases

3 months ago
Are you getting power outs/brownouts? If not check the power...

In forum General discussion, announcements and releases

4 months ago
On the last print is says 3 power failures and 3 filament ru...

In forum General discussion, announcements and releases

4 months ago
Printing stops and the MK3S+ resets...

In forum General discussion, announcements and releases

4 months ago
One final update. I enabled "Wipe while retracting" in the ...

In forum General discussion, announcements and releases

4 months ago
Yesterday I made a few minor changes that seemed to help con...

In forum General discussion, announcements and releases

4 months ago
I have not fully figured this out, but I have improved the s...

In forum General discussion, announcements and releases

4 months ago
Thanks for the suggestion. I should do that (temp tower). ...

In forum General discussion, announcements and releases

5 months ago
Thanks for the replies, but the problem isn't merely buildup...

In forum General discussion, announcements and releases

5 months ago
Causes of buildup on the nozzle?

In forum General discussion, announcements and releases

5 months ago
Carbon Fiber PETG vs PETG

In forum General discussion, announcements and releases

6 months ago
Tightening the door tension seems to have solved the problem...

In forum How do I print this? (Printing help)

6 months ago
My next experiment is to tighten the door tension screw. I ...

In forum How do I print this? (Printing help)

6 months ago
Both spools of black filament were properly vacuum sealed. ...

In forum How do I print this? (Printing help)

6 months ago
The mystery deepens. The problem occurred with spool of bla...

In forum How do I print this? (Printing help)

6 months ago
Rough surfaces?

In forum How do I print this? (Printing help)

6 months ago
Page 1 / 10
Share: