Notifications
Clear all
loadinglevelone
loadinglevelone
Groupe: Enregistré
A(ont) rejoint: 2020/01/06
Trusted Member
3
I agree. But then why do Prusa not mention this in the assem...

Dans le forum Assembly and first prints troubleshooting

il y a 11 months
Hotend assembly - pre-tightened from Prusa?

Dans le forum Assembly and first prints troubleshooting

il y a 12 months
@raymate Brand doesn't matter. It's the same for all brands....

Dans le forum General discussion, announcements and releases

il y a 2 years
I just recently upgraded the firmware of my MK3s to the leat...

Dans le forum How do I print this? (Printing help)

il y a 2 years
Is that a cheap IKEA table? Those are like pure resonance-ch...

Dans le forum General discussion, announcements and releases

il y a 2 years
I use it whenever I change between filament types. Going fro...

Dans le forum General discussion, announcements and releases

il y a 2 years
My printer have always had this clicking. Even from the very...

Dans le forum General discussion, announcements and releases

il y a 2 years
Gear seems to be in the correct position. Even checked that ...

Dans le forum General discussion, announcements and releases

il y a 2 years
Here I move the wheel by hand between the two endstops of th...

Dans le forum General discussion, announcements and releases

il y a 2 years
I spoke too soon. Just checked again when there was no filam...

Dans le forum General discussion, announcements and releases

il y a 2 years
I do get the same clicking when I move the larger gear by ha...

Dans le forum General discussion, announcements and releases

il y a 2 years
No filament sensor

Dans le forum General discussion, announcements and releases

il y a 2 years
www.youtube.com/watch?v=cLrA4Mj_uTM

Dans le forum General discussion, announcements and releases

il y a 2 years
*stupid forum edit timeout*... should be smaller inner beari...

Dans le forum General discussion, announcements and releases

il y a 2 years
That is the 100% exact same sound that I have. No question a...

Dans le forum General discussion, announcements and releases

il y a 2 years
@boom I tried this. Did not solve the clicking. Gears were p...

Dans le forum General discussion, announcements and releases

il y a 2 years
Nah.. don't agree. I'd rather wait a few more weeks to get p...

Dans le forum General discussion, announcements and releases

il y a 2 years
The cold pull looks just perfect. But remember that this is...

Dans le forum General discussion, announcements and releases

il y a 2 years
Sure, the new part work just as good as the 3D-printed ones....

Dans le forum General discussion, announcements and releases

il y a 2 years
Just got a brand new prusa mini - and get the exact same cli...

Dans le forum General discussion, announcements and releases

il y a 2 years
Page 1 / 3
Partager :