Activity
 
Notifications
Clear all
Ken G.
Ken G.
Group: Registered
Joined: 2019/11/30
Eminent Member
2
Selector motor burned out?

In forum Assembly and first prints troubleshooting

3 years ago
@alamatth I used 2.6 ID and 4 OD tubing thatI found on Amazo...

In forum Assembly and first prints troubleshooting

3 years ago
I read this in the instructions, I do believe that the perso...

In forum Assembly and first prints troubleshooting

3 years ago
Soluble filament

In forum How do I print this? (Printing help)

3 years ago
I get a small blob at the start of the purge line, especiall...

In forum Assembly and first prints troubleshooting

3 years ago
I had the same problem, I replaced it with one from a comput...

In forum Assembly and first prints troubleshooting

3 years ago
Soince you took the hot end out, it is probably a PINDA prob...

In forum Assembly and first prints troubleshooting

3 years ago
When that message pops up, it usually means that the points ...

In forum Assembly and first prints troubleshooting

3 years ago
They are the same IR sensor, I put mine aside as a spare.

In forum Assembly and first prints troubleshooting

3 years ago
rhdreambox is exactly correct, your first layer calibration ...

In forum Assembly and first prints troubleshooting

3 years ago
So far my needle bearings look good and I don't have excessi...

In forum Assembly and first prints troubleshooting

3 years ago
When you hooked all up, you made sure to connect the wires t...

In forum Assembly and first prints troubleshooting

3 years ago
Thank you for the info. I got it to slice, it is printing, a...

In forum How do I print this? (Printing help)

3 years ago
I was able to color something in meshmixer and export it in ...

In forum How do I print this? (Printing help)

3 years ago
Did the filament have unloading problems before you installe...

In forum Assembly and first prints troubleshooting

3 years ago
Hello Jason, It sounds like this is the original MMU2 not th...

In forum Assembly and first prints troubleshooting

3 years ago
I did away with the buffer and put two Ikea SAMLA boxes on t...

In forum Assembly and first prints troubleshooting

3 years ago
This should be part of the MMU, not a mod

In forum Assembly and first prints troubleshooting

3 years ago
Thanks all, I got it running! wepgden suggested a brilliant ...

In forum Assembly and first prints troubleshooting

3 years ago
@wpegden Yeah that mod is a must have! The MMU2S is up and w...

In forum Assembly and first prints troubleshooting

3 years ago
Page 1 / 3
Share: