Notifications
Clear all
Buckeye Slicer
Buckeye Slicer
Group: Registered
Joined: 2019/11/26
Eminent Member
2
Not sure what the error was. Something about temp. I cleared...

In forum How do I print this? (Printing help)

8 months ago
Print stopped partially through 16hr print. Need solutions

In forum How do I print this? (Printing help)

8 months ago
How Do I Change Filament Mid Print

In forum General discussion, announcements and releases

8 months ago
First Layer advice

In forum General discussion, announcements and releases

11 months ago
For some reason I cannot upgrade my Octoprint to 1.6.1 or 1....

In forum General discussion, announcements and releases

11 months ago
Got my problem solved. Washed the sheet with a generic dolla...

In forum General discussion, announcements and releases

11 months ago
I went from -0.750 to -0.875 and gave me a perfect square, p...

In forum General discussion, announcements and releases

11 months ago
Well, I guess I celebrated a little to early. Ran an STL, ba...

In forum General discussion, announcements and releases

11 months ago
One last question, that calibration gcode that Jeff Jordan m...

In forum General discussion, announcements and releases

11 months ago
Thanks everyone for your patience with me. I really apprecia...

In forum General discussion, announcements and releases

11 months ago
no you don't see any lines underneath, and yes it pulls off...

In forum General discussion, announcements and releases

11 months ago
-0.820 100% speed  16276721447907703817871929662459.j...

In forum General discussion, announcements and releases

11 months ago
Here's 3 different pictures. One picture went up to -750 at ...

In forum General discussion, announcements and releases

11 months ago
Ok, got it to stick, so we are now at -0.660, but as you can...

In forum General discussion, announcements and releases

11 months ago
I have used both alcohol, and washed with dish soap then alc...

In forum General discussion, announcements and releases

11 months ago
somewhere between -0.080 and -0.120 Back when I was having...

In forum General discussion, announcements and releases

11 months ago
Could not get PETG to stick to sheet, or adjusted. Keeps get...

In forum General discussion, announcements and releases

11 months ago
will send pic as soon as I can get one that doesn't goop up ...

In forum General discussion, announcements and releases

11 months ago
I have printed PETG, buy after I first got it, and must have...

In forum General discussion, announcements and releases

11 months ago
Not sure about this. Went down to -080 and had filament squi...

In forum General discussion, announcements and releases

11 months ago
Page 1 / 3
Share: