Notifications
Clear all
towlerg
towlerg
Group: Registered
Joined: 2019/10/20
Noble Member
3
Are you using a Mac?

In forum PrusaSlicer

3 days ago
Sys Admin Is it OK to slag off one of the most knowledgeable...

In forum PrusaSlicer

3 days ago
I suspect that using the cut function in Prusaslicer to isol...

In forum How do I print this? (Printing help)

4 days ago
If all else fails lay the heater block on the ring of an dom...

In forum Hardware, firmware and software help

4 days ago
I think that tells more about social media than it does abou...

In forum Assembly and first prints troubleshooting

6 days ago
I would recommend that you return the printer.

In forum Assembly and first prints troubleshooting

7 days ago
It appears that the paint on inside and outside seams are in...

In forum General discussion, announcements and releases

1 week ago
Possibly rights? I know it doesn't help you but non-Prusa pr...

In forum PrusaSlicer

1 week ago
I wonder what the max length of filament profile name is?

In forum PrusaSlicer

1 week ago
What file type are you trying to load?

In forum PrusaSlicer

1 week ago
2-3 days, that's even more incredible.

In forum Awesome prints (Hall Of Fame)

1 week ago
Make a copy. Click on save, change offered file name, amend.

In forum PrusaSlicer

1 week ago
It is important that the nozzle change tools I mentioned abo...

In forum General discussion, announcements and releases

1 week ago
Incredible, a Mk4, how long did it take to do the design?

In forum Awesome prints (Hall Of Fame)

2 weeks ago
I use ,swear by it, leaves one hand free to secure the heat...

In forum General discussion, announcements and releases

2 weeks ago
If you want to remove a section of apart, rotate and slice w...

In forum PrusaSlicer

2 weeks ago
Review nozzle installation instructions. Don't have a Mini b...

In forum Assembly and first prints troubleshooting

2 weeks ago
I'm old and probably far too stuck in the mud but I refuses ...

In forum PrusaSlicer

2 weeks ago
@karl Thanks for the info and particularly the link. BTW it...

In forum PrusaSlicer

2 weeks ago
Not sure what the problem is but M104 S[first_layer_temper...

In forum PrusaSlicer

3 weeks ago
Page 1 / 77
Share: