Activity
 
Notifications
Clear all
Matt
Matt
Group: Registered
Joined: 2019/08/12
Trusted Member
3
That's fixed it, Thanks!

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
To clarify, I interpreted the following instruction: "Look f...

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
Octoprint state "Offline after error" after initial setup

In forum User mods - OctoPrint, enclosures, nozzles, ...

6 months ago
@joantabb Yes, that's right. Having upgraded the v1 PINDA fr...

In forum Hardware, firmware and software help

1 year ago
I think it was specific to my MK3, in that whenever I tried ...

In forum General discussion, announcements and releases

1 year ago
(Checks RSS feed notification pop-up) Ahem - I mean the *new...

In forum General discussion, announcements and releases

1 year ago
I have a MK3S and MINI, both upgraded fully to plusses (I kn...

In forum General discussion, announcements and releases

1 year ago
Presumably this is the one that gets struck by lightning and...

In forum General discussion, announcements and releases

1 year ago
The upcoming 3.10.0 firmware for the MK3 series is going to ...

In forum General discussion, announcements and releases

1 year ago
Unfortunately 3D printing is not yet at the "off the shelf" ...

In forum Assembly and first prints troubleshooting

1 year ago
@raymate While you're doing that, check your hotend's PTFE t...

In forum General discussion, announcements and releases

1 year ago
@clarmrrsn It was a long weekend break for me and some of my...

In forum General discussion, announcements and releases

1 year ago
@clarmrrsn Falkirk? I was there a couple of years ago during...

In forum General discussion, announcements and releases

1 year ago
@schnoidz From someone who had no experience with Prusa prin...

In forum General discussion, announcements and releases

1 year ago
@royce All of my deliveries from Prusa have been wrapped in ...

In forum General discussion, announcements and releases

1 year ago
@cwbullet It's not going to make much of a difference. The f...

In forum General discussion, announcements and releases

1 year ago
The red light in the top of the MINDA probe goes on to indic...

In forum General discussion, announcements and releases

1 year ago
"System volume information" is a folder that sits in the roo...

In forum General discussion, announcements and releases

1 year ago
You don't, you only pay it once - Though the cost of the goo...

In forum General discussion, announcements and releases

1 year ago
I had this happen a few weeks into owning my MK3S, where aft...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 5
Share: