Notifications
Clear all
Quail333
Quail333
Group: Registered
Joined: 2019/04/25
Eminent Member
2
I think I am promoting a collaborative rather than adversari...

In forum Assembly and first prints troubleshooting

2 years ago
I don't think it is unreasonable to expect a reliable seal o...

In forum Assembly and first prints troubleshooting

2 years ago
Why not go all the way and torque the bolts progressively.

In forum Assembly and first prints troubleshooting

2 years ago
What we want is a reliable printer over time, this is the fi...

In forum Assembly and first prints troubleshooting

2 years ago
Seems like you have discovered a design flaw, it probably ne...

In forum Assembly and first prints troubleshooting

2 years ago
@ryan-c29 I would use the torque wrench every time for consi...

In forum Assembly and first prints troubleshooting

2 years ago
I have read the post and it seems you have not tried using a...

In forum Assembly and first prints troubleshooting

2 years ago
What about hitting the build plate with 320 sandpaper and th...

In forum Assembly and first prints troubleshooting

3 years ago
Maxwell, just to say I have dropped Sketchup and am learning...

In forum General discussion, announcements and releases

3 years ago
BIG THANKS.

In forum General discussion, announcements and releases

3 years ago
Most GENEROUS, could I send you $40.00?

In forum General discussion, announcements and releases

3 years ago
Phew, great, not a problem after all. Thanks for taking the ...

In forum General discussion, announcements and releases

3 years ago
Maxwell, I used optimal orientation and then auto support an...

In forum General discussion, announcements and releases

3 years ago
Maxwell, that was good, I have gone from idea to the 3d read...

In forum General discussion, announcements and releases

3 years ago
Whoo, THAT ROCKS, got it, that was balling me up, Thanks!

In forum General discussion, announcements and releases

3 years ago
Maxwell, I have done that but no changes in results. The hea...

In forum General discussion, announcements and releases

3 years ago
Thanks Maxwell, I prefer to keep my STL file private but her...

In forum General discussion, announcements and releases

3 years ago
Thanks again, I think I have tried the variants you suggeste...

In forum General discussion, announcements and releases

3 years ago
I have been playing with manual editing but you can not chan...

In forum General discussion, announcements and releases

3 years ago
Prusa Slicer Support Tweaks

In forum General discussion, announcements and releases

3 years ago
Page 1 / 2
Share: