Notifications
Clear all
Milhooz
Milhooz
Group: Registered
Joined: 2016/12/05
Trusted Member
3
Yes I will work on the MMU part at some point. I just wished...

In forum PrusaSlicer

2 years ago
Ironing in 2.3.0-alpha causes Prusament Jam on MK3/S

In forum PrusaSlicer

2 years ago
In my case, for the broken lid, they sent me a new one quick...

In forum General discussion, announcements and releases

2 years ago
@gscootusa Really surprised by your experience, the customer...

In forum Assembly and first prints troubleshooting

2 years ago
I've printed two of those, one without properly stirring the...

In forum How do I print this? (Printing help)

2 years ago
@dario-f The issue is that the white stain already appear ou...

In forum How do I print this? (Printing help)

2 years ago
Does your filament properly leaves the bond tech gears of th...

In forum Assembly and first prints troubleshooting

2 years ago
@mractor1 Bypass the MMU, you should be able to print as a n...

In forum Assembly and first prints troubleshooting

2 years ago
Some people said that it is working well by using the BVOH p...

In forum Assembly and first prints troubleshooting

2 years ago
Message for Prusa developers: Two easy firmware improvements...

In forum Assembly and first prints troubleshooting

2 years ago
I had the MMU1 which was a pain, and then I've got the MMU2 ...

In forum Assembly and first prints troubleshooting

2 years ago
@alrostom There is an additional part that you can print to ...

In forum Coronavirus (COVID-19)

2 years ago
Also make sure you don't clean the film with IPA. It will ma...

In forum Assembly and first prints troubleshooting

2 years ago
@monte I posted a link to Amazon for Buttonhole Elastic band...

In forum Coronavirus (COVID-19)

2 years ago
@danie-vandenberg Don't tell me to think, the link I send is...

In forum Coronavirus (COVID-19)

2 years ago
Sorry, I cannot edit my post anymore but here is the picture

In forum How do I print this? (Printing help)

2 years ago
Fuzzy/white walls

In forum How do I print this? (Printing help)

2 years ago
@slewis For the US, I recommend that you print this version ...

In forum Coronavirus (COVID-19)

2 years ago
The face shield is accepted in France, they have a created a...

In forum Coronavirus (COVID-19)

2 years ago
I tried to print the bike that Jo shared on twitter but I'm ...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 4
Share: